SIGNAL 19" racková skriňa (15U 600 mm, závesná)

SAFETY MEASURES

1. Use appropriate tools (such as transport carts) and a team of people to move the cabinet to avoid damage and injury.
2. Avoid tilting the cabinet during transport - stabilize it to prevent tipping.
3. Place the cabinet on a level surface and secure it using fasteners (e.g. to the floor, wall or frame).
4. Make sure that the system site of the cabinet is properly prepared:
- in the case of standing cabinets: the floor must be stable and strong, capable of bearing the weight of a fully loaded cabinet
- for wall-mounted cabinets: the wall must be strong enough (e.g. concrete, brick, solid gypsum board with reinforcement).
5. Use personal protective equipment, such as gloves, during installation. The cabinet may have steel parts with sharp edges.
6. Do not exceed the maximum load capacity of the cabinet.
7. Long components should be installed with the support of a second person stabilizing the component to avoid the possible fall of the component on the installer.
8. When moving the cabinet, be very careful and make sure that all components are tightened well.
9. Special care should be taken during installation of the glass door system. Installation should be done with the assistance of another person.
10. When installing devices, use dedicated rails, shelves or mounts according to the instructions of the cabinet and devices.
11. Install the cabinet grounding system in accordance with electrical safety standards.
12. Restrict access to the cabinet to trained persons only.
13. If damage (e.g. deformation, loose components) is detected, contact technical service.